You’ve mounted the hard drive to the case and made the electrical connection. Now it’s time to button the case back up, which is basically just a matter of reversing the disassembly process you performed earlier.
Put It Back Together
- Slide the hard drive carrier back into the case. Check the internal electrical wiring to make sure that no cables are pinched or in the way as you slide the case and carrier back together.
- Snap the rear panel back into place. Make sure the edges of the panel and the case line up and are a good fit. If they fail to line up, chances are a cable or wire in the case has been pinched and is preventing the case from closing completely.
- Screw the rear panel into place. You can use those two small screws you set aside earlier to finish closing the case.
